In the assembly of wiring harness processing plant, we should pay attention to what problems: in the assembly process, automotive wiring harness processing also needs to follow certain principles. Therefore, wiring harness manufacturers have addressed some of the issues that need attention when assembling electronic wiring harnesses:

1. In the assembly process, the price of the wiring harness processing plant will not pull the electronic wiring harness too tight, which can avoid shaking when the car is driving, resulting in the offset of the electronic wiring harness support point, which may lead to the expansion of the distance between the two support points, extend the electronic wiring harness, lead to series or disconnect the internal structure of the electronic wiring harness contact, and change the parameters of the transmission line, serious, The transmission line will remain disconnected.

2. After the assembly of the electronic wiring harness, there must be sufficient clearance around it to ensure that it is not subjected to pressure and tripping of other components to prevent damage to the cable sheath of the electronic wiring harness. Cracked or pinched, resulting in common faults such as grounding devices.

3. There is no layout in the close position, and the color and model specifications are the same, which can avoid misinsertion during the assembly process and damage to high-power electrical and electronic wiring harnesses.

4. The connector should be set in an area that is very easy to find, and set in an area that is very easy to control by special tools and their hands. The key is to check and maintain it regularly. The length of the transmission line should be considered according to the specific assembly situation. If the electrical part is installed in an area that is very easy to control, the direct transmission of the connector to the part can be omitted; If the installation parts of the electrical components are secret, it will be difficult to check and maintain in the middle and late stages. The transmission line length of electrical components can also be appropriately increased according to specific needs, so that the connector is set in an area conducive to inspection and maintenance.